Ricoma Help Center home page
Could not find the ticket form for id: 20833446358035

Centering the Head MT-1502

PUBLISHED

Here is the adjustment: Centering the head MT


After performing the cam adjustment on Head 1 or if you just see that Head 2 is not aligned over the needle plate.

If head #2 is not aligned but head #1 is, you would loosen these two screws located on head #2:






TAGS:
Need additional help?
Please don’t hesitate to reach out to us for further assistance via email at service@ricoma.com or by visiting our support page at www.ricoma.com/US/support.