Ricoma Help Center home page
Could not find the ticket form for id: 20833446358035

Setting Wifi for 2.4 Ghz to allow access from 10s Panel

PUBLISHED

To connect  your embroidery machine with a 10s control panel to a wifi network, it is a requirement currently to use the 2.4 Ghz setting on your wifi router, in which we have included some basic instructions below. This could be slightly different depending on each Wifi Router:

 

To set up a 2.4 GHz band with access to the home network, you can follow few steps:

  1. Get the IP address of your router.
  2. Enter the IP address in a browser.
  3. Login with your username and password.
  4. Click Advanced Settings tab.
  5. Click Network Settings.
  6. Enable the 2.4 GHz band.

 

 

Please don't hesitate to reach out if you encounter any challenges or have further inquiries. We're committed to ensuring your experience is smooth and successful.

TAGS:
Need additional help?
Please don’t hesitate to reach out to us for further assistance via email at service@ricoma.com or by visiting our support page at www.ricoma.com/US/support.